Registered Address: 32D Floor Guomao Building, No.388, Hubin South Road, Siming District, Xiamen,Fujian, China
21504-00-12-10-02 is a legacy 7200 Series 8 mm proximity probe with a 3/8-24 threaded case, no lead armor, 1.2 in case length, 1.0 m integral lead and miniature male coaxial connector. The matched legacy transducer system and complete probe geometry must be verified before replacement.
21504-00-12-10-02 is a legacy 7200 Series 8 mm proximity probe with a 3/8-24 threaded case, no lead armor, 1.2 in case length, 1.0 m integral lead and miniature male coaxial connector. The matched legacy transducer system and complete probe geometry must be verified before replacement.
Before replacement, record the complete label, installed position, mounting or cable arrangement, receiving channel and retained settings. After installation, verify the signal baseline, diagnostics and every affected monitoring or protection function.
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
21504-00-12-10-02 is a legacy 7200 Series 8 mm proximity probe with a 3/8-24 threaded case, no lead armor, 1.2 in case length, 1.0 m integral lead and miniature male coaxial connector. The matched legacy transducer system and complete probe geometry must be verified before replacement.
Match the mounting geometry, cable or connector execution, receiving monitor, electrical length and approved system documentation. Preserve every installed reference and accessory before removal.
After installation, inspect connector seating and cable routing, verify the saved signal baseline and diagnostics, and prove every affected monitoring or protection function under an approved controlled procedure.
21504-00-12-10-02 is a legacy 7200 Series 8 mm proximity probe with a 3/8-24 threaded case, no lead armor, 1.2 in case length, 1.0 m integral lead and miniature male coaxial connector. The matched legacy transducer system and complete probe geometry must be verified before replacement.
Confirm the complete matched probe, extension cable, Proximitor sensor or receiving monitor as applicable. Record mounting, connector, cable route and channel settings before removal; then verify the full signal chain after installation.
Obsolete / Discontinued by OEM
Moore Automated supplies verified industrial automation components and carefully inspects the exact item before shipment to support stable operation and reduce unexpected production downtime.