Overview
Manuals
Armored Cable Design
System Compatibility
Signal-Chain Setup
Features:
- The documented value for type is 3-conductor shielded Cables; retain this specification when matching the exact armored interconnect cable and installed Bently Nevada 3300 hardware.
- The documented value for minimum length is 3.0 ft (0.9 m); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented value for maximum length is 99 ft (30 m); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
16710-17 is a Bently Nevada Armored Interconnect Cable for the 3300 system. It connects the probe to a compatible Proximitor Sensor. Key specifications: Type: 3-conductor shielded Cables; Minimum length: 3.0 ft (0.9 m). Match the full order code and hardware before replacement.
Confirm the complete 16710-17 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The 16710-17 Bently Nevada Armored Interconnect Cable may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Bently Nevada 16710-17 Armored Interconnect Cable manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Review 16710-17 by complete length and construction code. Retained facts: Type: 3-conductor shielded Cables; Minimum length: 3.0 ft (0.9 m); maximum length: 99 ft (30 m). Do not change the calibrated total system length when replacing an extension or integral lead.
Match every connector, protector, armor or FluidLoc option and the receiving probe/Proximitor Sensor. Route the cable without sharp bends, crushing, connector side-load or contamination.
Inspect continuity and insulation where applicable, seat the connectors, compare channel bias with the recorded value and confirm stable vibration or position response before release.
