Overview
Manuals
Cable Construction
System Compatibility
Signal-Chain Setup
Features:
- The documented value for voltage rating is Rated for ≤ 250V AC/DC; use this value when checking the monitor configuration, operating limits and expected measurement response.
- The documented value for temperature range is -40°C to +120°C; use this value when checking the monitor configuration, operating limits and expected measurement response.
- The documented value for impedance is 50–100 Ω; retain this specification when matching the exact 3300 proximity probe extension cable and installed Bently Nevada 3300 hardware.
21474-075-00 is a Bently Nevada 3300 Proximity Probe Extension Cable for the 3300 system. It connects the probe to a compatible Proximitor Sensor. Key specifications: Voltage Rating: Rated for ≤ 250V AC/DC; Temperature Range: -40°C to +120°C. Match the full order code and hardware before replacement.
Confirm the complete 21474-075-00 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The exact 21474-075-00 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 21474-075-00 3300 Proximity Probe Extension Cable manual (Datasheet), Link
No verified product-specific PDF is attached to this listing.
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Review 21474-075-00 by complete length and construction code. Retained facts: Voltage Rating: Rated for ≤ 250V AC/DC; Temperature Range: -40°C to +120°C; Impedance: 50–100 Ω. Do not change the calibrated total system length when replacing an extension or integral lead.
Match every connector, protector, armor or FluidLoc option and the receiving probe/Proximitor Sensor. Route the cable without sharp bends, crushing, connector side-load or contamination.
Inspect continuity and insulation where applicable, seat the connectors, compare channel bias with the recorded value and confirm stable vibration or position response before release.
