Overview
Manuals
Ordering Code
System Matching
Installation Guidance
Features:
- Non-armored 3300 XL 8 mm proximity probe with a 3/8-24 UNF body for documented non-contact shaft measurements.
- Code defines 0.0 inch unthreaded length, 6.0 inch overall case length and 9.0 m total length for the installed cable route.
- Connector-protector option 01 and approval option 05 preserve the exact ordering configuration when matched to the correct extension cable and Proximitor sensor.
330101-00-60-90-01-05 Bently Nevada 330101-00-60-90-01-05 is a 3300 XL 8 mm proximity probe for non-contact shaft-relative measurements in compatible machinery-monitoring systems. Its complete ordering code selects the 3/8-24 UNF non-armored probe body, 0.0 inch unthreaded length, 6.0 inch overall case length, 9.0 m total length, connector-protection option 01 and approval option 05. Correct operation depends on the documented extension cable, Proximitor sensor, target material, mounting geometry and probe-gap setup.
Official source: Bently Nevada 3300 XL 8 mm Proximity Transducer System Datasheet 141194. Ordering-code selections and system matching must be verified against the installed nameplate.
330101-00-60-90-01-05 technical documentation and verified Moore Automated resources.
Important Notice: Match the complete probe code and transducer chain before installation.
The complete suffix identifies the recorded mechanical length, total cable length, connector protection and approval option. Keep all six code groups together when checking a replacement against the installed nameplate.
Connect the probe only to the specified 3300 XL 8 mm extension cable and Proximitor sensor. The combined electrical length, connector condition, target material and monitor configuration determine valid operation.
Confirm the 3/8-24 UNF thread, 6.0 inch case clearance and 9.0 m cable route before installation. Set the probe gap and verify channel response using the applicable monitoring-system procedure.
