Overview
Manuals
Cable Construction
Long-Lead Routing
Signal-Chain Setup
Features:
- The documented value for cable length is 8.0 meters (26.2 feet); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented value for connector and cable is Standard cable with connector protector; verify the connector interface, electrical length and matching 3300 signal-chain components before commissioning.
- The documented value for agency approval is Not required; the complete approval suffix must match the installation area and site requirements.
330730-80-02-00 is a Bently Nevada 3300 XL 11 mm Extension Cable for the 3300 system. It connects the probe to a compatible Proximitor Sensor. Key specifications: Cable Length: 8.0 meters (26.2 feet); Connector and Cable: Standard cable with connector protector. Match the full order code and hardware before replacement.
Confirm the complete 330730-80-02-00 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The exact 330730-80-02-00 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 330730-80-02-00 3300 XL 11 mm Extension Cable manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Review 330730-80-02-00 by complete length and construction code. Retained facts: Cable Length: 8.0 meters (26.2 feet); Connector and Cable: Standard cable with connector protector; Agency Approval: Not required. Do not change the calibrated total system length when replacing an extension or integral lead.
Match every connector, protector, armor or FluidLoc option and the receiving probe/Proximitor Sensor. Route the cable without sharp bends, crushing, connector side-load or contamination.
Inspect continuity and insulation where applicable, seat the connectors, compare channel bias with the recorded value and confirm stable vibration or position response before release.
