Overview
Manuals
Standard Probe Mounting
System Compatibility
Signal-Chain Setup
Features:
- The documented value for diameter is 8 mm; retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented value for linear range is Typically 2mm; use this value when checking the monitor configuration, operating limits and expected measurement response.
- The documented value for sensitivity is -7.874 mV/µm (-200 mV/mil); use this value when checking the monitor configuration, operating limits and expected measurement response.
APP1407030-00100 is a Bently Nevada COOPER Vibration Probe for the 3300 system. It measures shaft vibration or position without contact in a matched transducer chain. Key specifications: Diameter: 8 mm; Linear Range: Typically 2mm. Match the full order code and hardware before replacement.
Confirm the complete APP1407030-00100 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The exact APP1407030-00100 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada APP1407030-00100 COOPER Vibration Probe manual (Datasheet), Link
No verified product-specific PDF is attached to this listing.
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Preserve every option block of APP1407030-00100. Retained facts: Diameter: 8 mm; Linear Range: Typically 2mm; Sensitivity: -7.874 mV/µm (-200 mV/mil). Mechanical length, thread, cable/connector and approval suffixes are part of the exact probe identity.
Match probe family, electrical length, extension cable and Proximitor Sensor. Confirm target material, available travel, nearby probe spacing and mounting geometry before exchange.
Set the operating gap from live bias voltage, support the cable above its bend limit and verify runout, vibration or position response against the commissioning baseline.
