Registered Address: 32D Floor Guomao Building, No.388, Hubin South Road, Siming District, Xiamen,Fujian, China
The General Electric IC695CPU320 is a cpu processor module for PACSystems RX3i industrial automation applications. Documented product details include PACSystem RX3i Processor module; This module occupies Two (2) slots; processor speed of 1GHz with typical; scan rate of 0.047 ms per 1000; Boolean instructions. Confirm the complete model code, hardware revision and supplied condition against the installed equipment before replacement.
Verify that the supplied item is marked IC695CPU320 and that its cpu processor module form, connectors and revision agree with the approved PACSystems RX3i receiving record.
For IC695CPU320, state the required condition, quantity, installed position, connected assemblies and document requirements in the written enquiry.
Apply only parameters supported by the exact IC695CPU320 record or a documented family source. Do not infer electrical ratings or interchangeability from appearance.
IC695CPU320 technical scope: Product Type: CPU module; Product Line: RX3i PacSystem; Microprocessor: Celeron M; Clock Speed: 1.0 Gigahertz; RAM: 64 Megabytes.
Use these values only for the listed hardware execution and verify the supplied label before installation.
Match IC695CPU320 to the approved PACSystems RX3i receiving position, connector or terminal arrangement and configuration record.
After power restoration, review diagnostics and test the affected cpu processor module path.
Active / Available from OEM
IC695CPU320 is a General Electric cpu processor module associated with the PACSystems RX3i platform. It supports the documented controller execution, communications and configuration functions assigned to the installed processor position. Correct selection depends on the complete model code, connector or terminal arrangement, hardware revision and receiving-system configuration. Before replacement, compare the original product label, installed slot or cabinet reference, connected assemblies and approved project records. After installation, review system diagnostics and function-test every affected channel, control path, protection function or communication link before returning the equipment to service.