Registered Address: 32D Floor Guomao Building, No.388, Hubin South Road, Siming District, Xiamen,Fujian, China
The General Electric IC695SPF002A is a scanner module for PACSystems RX3i industrial automation applications. Documented product details include Fanuc Automation small; form-factor pluggable scanner; module has a speed of 100 Mbps; It requires a power rating of 3.3 to 5 Volts. Confirm the complete model code, hardware revision and supplied condition against the installed equipment before replacement.
Verify that the supplied item is marked IC695SPF002A and that its scanner module form, connectors and revision agree with the approved PACSystems RX3i receiving record.
For IC695SPF002A, state the required condition, quantity, installed position, connected assemblies and document requirements in the written enquiry.
Apply only parameters supported by the exact IC695SPF002A record or a documented family source. Do not infer electrical ratings or interchangeability from appearance.
IC695SPF002A technical scope: Category Series: RX3i PacSystem; Speed: 100 Mbps; Length: 2 Kilometers; Power: 3.3 to 5 Volts; Port Connectors: Two RJ-45 and two SFP cages.
Use these values only for the listed hardware execution and verify the supplied label before installation.
Match IC695SPF002A to the approved PACSystems RX3i receiving position, connector or terminal arrangement and configuration record.
After power restoration, review diagnostics and test the affected scanner module path.
Active / Available from OEM
IC695SPF002A is a General Electric scanner module associated with the PACSystems RX3i platform. It supports the documented automation function assigned to its installed module, rack or cabinet position. Correct selection depends on the complete model code, connector or terminal arrangement, hardware revision and receiving-system configuration. Before replacement, compare the original product label, installed slot or cabinet reference, connected assemblies and approved project records. After installation, review system diagnostics and function-test every affected channel, control path, protection function or communication link before returning the equipment to service.