Registered Address: 32D Floor Guomao Building, No.388, Hubin South Road, Siming District, Xiamen,Fujian, China

The General Electric QPL-2D200-C2P is an operator panel for the GE QuickPanel platform. It provides a local operator interface for machine monitoring, status display and control. Confirm the complete model code, hardware revision, interfaces and supplied condition against the installed equipment before replacement.
Verify that the supplied item is marked QPL-2D200-C2P and that its operator panel form, connectors and revision agree with the approved GE QuickPanel receiving record.
For QPL-2D200-C2P, state the required condition, quantity, installed position, connected assemblies and document requirements in the written enquiry.
Apply only parameters supported by the exact QPL-2D200-C2P record or a documented family source. Do not infer electrical ratings or interchangeability from appearance.
QPL-2D200-C2P technical scope: Operating Voltage: 85 to 132 VAC; Power Consumption: 50 VA max; Power Failure Immunity: 20 ms max; Withstand Voltage: 1500 VAC (10 mA max, 1 min); Insulation Resistance: 10 MΩ @ 500 VDC.
Use these values only for the listed hardware execution and verify the supplied label before installation.
Match QPL-2D200-C2P to the approved GE QuickPanel receiving position, connector or terminal arrangement and configuration record.
After power restoration, review diagnostics and test the affected operator panel path.
Active / Available from OEM
QPL-2D200-C2P is a General Electric operator panel associated with the GE QuickPanel platform. It supports the documented automation function assigned to its installed module, rack or cabinet position. Correct selection depends on the complete model code, connector or terminal arrangement, hardware revision and receiving-system configuration. Before replacement, compare the original product label, installed slot or cabinet reference, connected assemblies and approved project records. After installation, review system diagnostics and function-test every affected channel, control path, protection function or communication link before returning the equipment to service.