Overview
Manuals
Card Identity
Station Compatibility
Replacement Checks
Features:
- Exact card identity combines FC11*A with assembly number S9051BE-0.
- Designed for the legacy Yokogawa CENTUM-XL control-system platform.
- Replacement must be based on the installed station slot, assembly revision, connector arrangement and system documentation.
The FC11*A card belongs to the Yokogawa CENTUM-XL hardware platform and is identified more precisely by assembly number S9051BE-0. It is used within an installed control-system station, where its operating role depends on the rack, assigned slot, adjacent cards, connector arrangement and the engineering configuration retained for that particular CENTUM-XL installation.
This is legacy system hardware, and the available verified record does not establish detailed electrical ratings or protocol behavior for every FC11*A execution. For a reliable replacement, both board markings must be matched and the station layout, revision, switch settings and connector positions must be recorded from the installed unit. Compatibility should be determined from the station-specific Yokogawa documentation rather than appearance alone.
The FC11*A AS S9051BE-0 Yokogawa CENTUM-XL Interface and Control Card may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Yokogawa FC11*A AS S9051BE-0 documentation and reference links.
Important Notice: The first link uses the verified product family because no qualified exact-model manufacturer PDF was confirmed. Confirm the complete order code, revision, connected hardware and installation requirements before replacement. Accessories, software and certificates are included only when stated in the written quotation.
Match FC11*A and S9051BE-0 on the supplied card; record every suffix, revision and assembly marking before installation.
Confirm the CENTUM-XL station, rack, slot, adjacent-card arrangement, firmware requirements and any duplex or paired configuration.
Photograph connectors and switch settings, isolate the system correctly, install the matched card and complete the station's documented diagnostic and redundancy checks.
