Overview
Manuals
Valve Control
Pneumatic Fit
Paint-System Service
Features:
- 3HNA026682-001 performs the documented Function Valve Module 16V function within the approved ABB equipment configuration.
- 3HNA026682-001 is intended for ABB paint robot pneumatic systems installations whose complete hardware and installed configuration match the original equipment.
- 3HNA026682-001 performs the documented sixteen-valve process-function control function within the approved ABB equipment configuration.
ABB 3HNA026682-001 is a function valve module 16v for ABB paint robot pneumatic systems. It performs sixteen-valve process-function control; compatibility depends on the complete article number, robot or controller variant, revision, mounting position and connected equipment. Isolate all energy sources before service, follow ABB maintenance instructions and complete mechanical, electrical and functional checks before returning the equipment to operation.
Before replacing 3HNA026682-001, record the installed position, hardware revision, mounting or connector arrangement, paired assemblies and every applicable ABB service record. Compare the supplied unit with the original item and approved configuration, isolate all relevant energy sources, and follow the documented installation procedure. After installation, inspect every affected mechanical, electrical and communication interface and complete controlled functional checks before returning the equipment to service.
The 3HNA026682-001 ABB Function Valve Module 16V is listed as Active / Available from OEM. Current revision, availability and supplied scope are confirmed in the written quotation.
ABB 3HNA026682-001 Function Valve Module 16V Manuals / Datasheets / Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
The module supports the documented function-valve arrangement in ABB paint-robot pneumatic systems. Match the valve count, connector layout and article revision before replacement.
Confirm the paint-robot pneumatic assembly, tubing connections and mounting position. The module should be checked with the complete air-control configuration.
Isolate pneumatic pressure and electrical supply, label each valve connection and run a controlled function test after installation.
