Overview
Manuals
Lead Matching
Carrier Match
Signal Testing
Features:
- Extension Cable for the documented Bently Nevada 3300 transducer cabling.
- Measuring range: 0–1.0 mm (0–40 mils).
- Sensitivity: 200 mV/mil (7.87 mV/μm).
102045-040-00 belongs to the Bently Nevada 3300 transducer cabling and performs the documented extension cable role in the Bently Nevada proximity measurement system. The retained technical evidence records Measuring range: 0–1.0 mm (0–40 mils); Sensitivity: 200 mV/mil (7.87 mV/μm); Frequency response: 0.1 Hz to 10 kHz (±3 dB). The full marking, receiving hardware, connectors or terminals, configuration dependencies and installed position must be matched before substitution.
For installation, retain the Bently Nevada 3300 transducer cabling receiving position, connector or terminal arrangement and configuration record. After power restoration, review diagnostics and test the affected operating path before process release.
The 102045-040-00 Extension Cable is supplied only after the complete hardware identity, condition and current OEM lifecycle status have been confirmed.
102045-040-00 Bently Nevada product documentation and selection resources.
Important Notice: The uploaded PDF documents the listed model or its identified Bently Nevada product family. Confirm the complete order code, hardware revision and installed-system requirements before replacement. Accessories, cables, software and certificates are included only when stated in the quotation. All prices are shown in USD.
Lead Matching: 102045-040-00 performs the extension cable function within the Bently Nevada 3300 transducer cabling. The retained documentation identifies measuring range as 0–1.0 mm (0–40 mils); apply that value only to this documented execution.
Match the complete label, hardware form and functional position before transferring any setting, cable or termination from the removed unit.
Carrier Match: approve 102045-040-00 only for the documented Bently Nevada proximity measurement system. Compare rack, carrier or panel generation, connector keying, terminal numbering and all paired assemblies with the installation drawings.
Photograph both sides and the installed position before removal so revision markings, jumpers, addressing and channel allocation can be reconstructed accurately.
Signal Testing: isolate the equipment, remove stored energy and inspect the receiving hardware before installing 102045-040-00.
Restore power in the approved sequence, review status and diagnostics, then test every affected control, signal, relay, communication, protection or monitoring path against the commissioning record.
