Overview
Manuals
Loop Wiring
Platform Review
Validation Steps
Features:
- Extension Cable for the documented Bently Nevada 3300 transducer cabling.
- Cable Length: 4.00 metres (157 inches).
- Armor: Without armor.
21747-040-00 belongs to the Bently Nevada 3300 transducer cabling and performs the documented extension cable role in the Bently Nevada proximity measurement system. The retained technical evidence records Cable Length: 4.00 metres (157 inches); Armor: Without armor; Operating Temperature: -30°F to +350°F (-34°C to +177°C). The full marking, receiving hardware, connectors or terminals, configuration dependencies and installed position must be matched before substitution.
For installation, retain the Bently Nevada 3300 transducer cabling receiving position, connector or terminal arrangement and configuration record. After power restoration, review diagnostics and test the affected operating path before process release.
The 21747-040-00 Extension Cable is supplied only after the complete hardware identity, condition and current OEM lifecycle status have been confirmed.
21747-040-00 Bently Nevada product documentation and selection resources.
Important Notice: The uploaded PDF documents the listed model or its identified Bently Nevada product family. Confirm the complete order code, hardware revision and installed-system requirements before replacement. Accessories, cables, software and certificates are included only when stated in the quotation. All prices are shown in USD.
Loop Wiring: 21747-040-00 performs the extension cable function within the Bently Nevada 3300 transducer cabling. The retained documentation identifies cable length as 4.00 metres (157 inches); apply that value only to this documented execution.
Match the complete label, hardware form and functional position before transferring any setting, cable or termination from the removed unit.
Platform Review: approve 21747-040-00 only for the documented Bently Nevada proximity measurement system. Compare rack, carrier or panel generation, connector keying, terminal numbering and all paired assemblies with the installation drawings.
Photograph both sides and the installed position before removal so revision markings, jumpers, addressing and channel allocation can be reconstructed accurately.
Validation Steps: isolate the equipment, remove stored energy and inspect the receiving hardware before installing 21747-040-00.
Restore power in the approved sequence, review status and diagnostics, then test every affected control, signal, relay, communication, protection or monitoring path against the commissioning record.
