Overview
Manuals
01-10 Probe Options
Mechanical Installation Fit
Signal Setup Checks
Features:
- The documented value for probe diameter is 5 mm; retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented value for thread size is 3/8-24 UNF; confirm the installed mounting interface, available reach and mechanical clearance before replacement.
- The documented value for probe length is 1 meter; retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
130938-01-10-01 is a Bently Nevada Eddy Current Proximity Probe for the 3300 system. It measures shaft vibration or position without contact in a matched transducer chain. Key specifications: Probe Diameter: 5 mm; Thread Size: 3/8-24 UNF. Match the full order code and hardware before replacement.
Confirm the complete 130938-01-10-01 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The exact 130938-01-10-01 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 130938-01-10-01 Eddy Current Proximity Probe manual (Datasheet), Link
No verified product-specific PDF is attached to this listing.
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Preserve every option block of 130938-01-10-01. Retained facts: Probe Diameter: 5 mm; Thread Size: 3/8-24 UNF; Probe Length: 1 meter. Mechanical length, thread, cable/connector and approval suffixes are part of the exact probe identity.
Match probe family, electrical length, extension cable and Proximitor Sensor. Confirm target material, available travel, nearby probe spacing and mounting geometry before exchange.
Set the operating gap from live bias voltage, support the cable above its bend limit and verify runout, vibration or position response against the commissioning baseline.
