Overview
Manuals
Probe Housing Selection
Direct Probe Mounting
Threaded Conduit Entry
Features:
- The documented value for probe with connector is Probe not required; verify the connector interface, electrical length and matching 3300 signal-chain components before commissioning.
- The documented value for probe cable length is Probe cable not required; retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented value for standoff adapter is No standoff adapter; retain this specification when matching the exact 21000 proximity probe housing assembly and installed probe-system hardware.
21000-00-00-00-064-01-02 is a Bently Nevada 21000 Proximity Probe Housing Assembly for external proximity-probe mounting. It provides probe mounting, adjustment and environmental protection. Key specifications: Probe with Connector: Probe not required; Probe Cable Length: Probe cable not required. Match the full order code and hardware before replacement.
Confirm the complete 21000-00-00-00-064-01-02 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The exact 21000-00-00-00-064-01-02 execution must be confirmed by its complete order code, condition, connected proximity-probe measurement system and included scope before purchase or replacement.
Bently Nevada 21000-00-00-00-064-01-02 21000 Proximity Probe Housing Assembly manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Check the complete 21000-00-00-00-064-01-02 housing code against the documented material, probe penetration, thread, fittings and access arrangement. Retained facts: Probe with Connector: Probe not required; Probe Cable Length: Probe cable not required; Standoff Adapter: No standoff adapter.
Confirm the installed probe, standoff, conduit fittings, sealing and machine-case interface together. A matching outside shape alone does not establish interchangeability.
Verify probe travel and gap access, tighten fittings to the approved practice, confirm sealing and route the probe lead without damage before returning the machine to service.
