Overview
Manuals
Probe Setup
System Fit
Gap Setup
Features:
- 330102-00-40-05-01-05 is identified by probe thread 3/8-24 UNF with armor within the documented 3300 XL 8 mm proximity transducer system configuration.
- The official specification gives unthreaded length as 0.0 in, which must be retained during selection.
- Commissioning must also preserve overall case length (4.0 in) and the stated connection limits.
A standard-mount 3300 XL 8 mm proximity probe with armor for non-contact rotating-shaft measurements. Its code specifies 0.0 in unthreaded length, 4.0 in overall case length, 0.5 m standard lead, protected ClickLoc connector and multiple approvals. Selection must preserve the complete label identity, connected-equipment compatibility and manufacturer installation limits.
Manufacturer reference: official 3300 XL 8 mm proximity transducer system documentation.
Moore Automated supports exact-item verification and spare-part enquiries for 330102-00-40-05-01-05.
Bently Nevada 330102-00-40-05-01-05 official manufacturer document excerpt (PDF), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Confirm the complete 330102-00-40-05-01-05 identity and compare probe thread, unthreaded length and overall case length with the installed design before approving a replacement.
Match the probe to the required 3300 XL 8 mm extension cable and Proximitor total length. Preserve 0.5 m probe lead allocation, ClickLoc interface and channel calibration.
Route the armor without tight bends, lock the 4.0 in case at the calculated insertion depth, connect and protect the ClickLoc joint, set the gap and verify the complete transducer response.
