Overview
Manuals
Routine Probe Setup
Local Cable Routing
Signal-Chain Setup
Features:
- The documented value for total length is 1.0 meter (3.3 feet); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented value for agency approval is Not required; the complete approval suffix must match the installation area and site requirements.
- The documented value for operating and storage temperature is -52°C to +218°C for the probe tip;- 51°C to +260°C for the probe cable and connector; use this value when checking the monitor configuration, operating limits and expected measurement response.
330196-05-30-10-00 is a Bently Nevada 3300 XL 8 mm Proximity Probes for the 3300 system. It measures shaft vibration or position without contact in a matched transducer chain. Key specifications: Total Length: 1.0 meter (3.3 feet); Agency Approval: Not required. Match the full order code and hardware before replacement.
Confirm the complete 330196-05-30-10-00 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The 330196-05-30-10-00 Bently Nevada 3300 XL 8 mm Proximity Probes may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Bently Nevada 330196-05-30-10-00 3300 XL 8 mm Proximity Probes manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Preserve every option block of 330196-05-30-10-00. Retained facts: Total Length: 1.0 meter (3.3 feet); Agency Approval: Not required; Operating and Storage Temperature: -52°C to +218°C for the probe tip;- 51°C to +260°C for the probe cable and connector. Mechanical length, thread, cable/connector and approval suffixes are part of the exact probe identity.
Match probe family, electrical length, extension cable and Proximitor Sensor. Confirm target material, available travel, nearby probe spacing and mounting geometry before exchange.
Set the operating gap from live bias voltage, support the cable above its bend limit and verify runout, vibration or position response against the commissioning baseline.
