Overview
Manuals
Heat-Resistant Cable
Standard Cable Routing
Signal-Chain Setup
Features:
- The documented value for type is 3300 XL 25 mm Extension Cable; retain this specification when matching the exact 3300 xl 25 mm extension cable and installed Bently Nevada 3300 hardware.
- The documented value for cable length option is 4.0 metres (13.1 feet); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented armor configuration is Armored High Temperature FluidLoc cable; preserve this construction together with the complete order code and cable-routing requirements.
330854-040-25-CN is a Bently Nevada 3300 XL 25 mm Extension Cable for the 3300 system. It connects the probe to a compatible Proximitor Sensor. Key specifications: Type: 3300 XL 25 mm Extension Cable; Cable Length Option: 4.0 metres (13.1 feet). Match the full order code and hardware before replacement.
Confirm the complete 330854-040-25-CN order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The exact 330854-040-25-CN execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 330854-040-25-CN 3300 XL 25 mm Extension Cable manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Review 330854-040-25-CN by complete length and construction code. Retained facts: Type: 3300 XL 25 mm Extension Cable; Cable Length Option: 4.0 metres (13.1 feet); Armor and Cable Option: Armored High Temperature FluidLoc cable. Do not change the calibrated total system length when replacing an extension or integral lead.
Match every connector, protector, armor or FluidLoc option and the receiving probe/Proximitor Sensor. Route the cable without sharp bends, crushing, connector side-load or contamination.
Inspect continuity and insulation where applicable, seat the connectors, compare channel bias with the recorded value and confirm stable vibration or position response before release.
