Overview
Manuals
Cable Selection
Accelerometer Compatibility
Cable Installation
Features:
- Armored interconnect cable for Bently Nevada 330400 and 330425 accelerometers.
- Three-conductor shielded 22 AWG (0.5 mm²) construction.
- Six-foot execution with a three-socket plug and terminal lugs.
16710-06 is a 6 ft (1.8 m) Bently Nevada armored accelerometer interconnect cable for 330400 and 330425 accelerometers. It uses three shielded 22 AWG (0.5 mm²) conductors, a three-socket accelerometer plug and terminal lugs. Verify the complete part number, route length, connector and terminations before replacement.
Before replacement, record the connected accelerometer, receiving terminals, conductor assignments, shield grounding and cable route. After installation, verify continuity, excitation, output bias and the affected vibration signal.
The 16710-06 Bently Nevada Armored Accelerometer Interconnect Cable is listed as Active / Available from OEM. Current revision, availability and supplied scope are confirmed in the written quotation.
16710-06 Bently Nevada 330400/330425 accelerometer cable documentation.
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
16710-06 specifies a 6 ft (approximately 1.8 m) armored cable with three shielded 22 AWG (0.5 mm²) conductors, a three-socket accelerometer plug and terminal lugs. Match the complete cable marking, required route length and both endpoint types before replacement.
Preserve the approved bend protection, strain relief, shield grounding and conductor assignments during installation.
The official Bently Nevada ordering table lists the 16710 cable family for 330400 and 330425 accelerometers. Confirm the connected accelerometer identity, connector condition, excitation source and receiving monitor terminals before approving 16710-06.
Do not select this cable from appearance or length alone; the armored construction, three-socket plug and terminal-lug field end must all match.
After installation, verify conductor and shield continuity, connector seating, terminal-lug tightness and the documented shield-grounding arrangement.
Restore the accelerometer loop in the approved sequence, then verify excitation, output bias, noise level and a representative vibration signal at the receiving monitor.
