Overview
Manuals
Orientation & Band
Connector Wiring
Isolated Base Setup
Features:
- Orientation option 06 supports 0° ±100° installation with a documented 10 Hz minimum operating frequency.
- The top connector and isolated circular M10 x 1 base define the cable interface and machine mounting arrangement.
- A 20 mV/mm/s two-wire output, 25 mm/s peak range and option-04 approvals support engineered casing-vibration monitoring.
Bently Nevada 9200-06-01-11-04 is a two-wire Seismoprobe velocity transducer configured for a 0° ±100° mounting orientation. Option 06 sets a 10 Hz minimum operating frequency, option 01 supplies the top connector without a cable, and option 11 provides an isolated circular M10 x 1 base. The final 04 suffix identifies the ATEX/IECEx version. The transducer generates a self-contained velocity signal with 20 mV/mm/s sensitivity and a nominal 10 Hz to 1 kHz response. Its mechanical moving-coil construction requires the orientation, base, connector, cable, mounting torque and receiving-input characteristics to be checked before installation. A similar 74712 high-temperature Seismoprobe or another 9200 orientation is not an automatic replacement.
Manufacturer reference: official 9200 Seismoprobe Velocity Transducer documentation.
Moore Automated supports exact-item verification and spare-part enquiries for 9200-06-01-11-04.
Bently Nevada 9200-06-01-11-04 Two-wire velocity transducer manual (Datasheet), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Keep the installed direction inside 0° ±100° and confirm that the required measurement spectrum begins at or above 10 Hz.
Verify the separate field cable, two-wire polarity, shielding and receiving-channel sensitivity before energizing the loop.
Use the M10 x 1 circular base on a rigid surface and preserve the manufacturer isolation and approval requirements.
