Overview
Manuals
Output Control
Interface Review
Site Testing
Features:
- Eddy Current Signal Converter for the documented Emerson DeltaV.
- Linear Measurement Range: 2 mm (80 mils).
- Initial Air Gap: 0.5 mm (20 mils).
PR6424/000-040 CON021 belongs to the Emerson DeltaV and performs the documented eddy current signal converter role in the Emerson DeltaV distributed control system. The retained technical evidence records Linear Measurement Range: 2 mm (80 mils); Initial Air Gap: 0.5 mm (20 mils); Minimum Shaft Diameter: 25 mm (0.79”). The full marking, receiving hardware, connectors or terminals, configuration dependencies and installed position must be matched before substitution.
For installation, retain the Emerson DeltaV receiving position, connector or terminal arrangement and configuration record. After power restoration, review diagnostics and test the affected operating path before process release.
The PR6424/000-040 CON021 Eddy Current Signal Converter is supplied only after the complete hardware identity, condition and current OEM lifecycle status have been confirmed.
Emerson PR6424/000-040 CON021 Eddy Current Signal Converter Manual(Datasheets), Link
Important Notice: The linked document or internal product-family information must identify the listed model or its documented family. Confirm the complete order code, hardware revision and installed-system requirements before replacement. Accessories, cables, software and certificates are included only when stated in the quotation. All prices are shown in USD.
Output Control: PR6424/000-040 CON021 performs the eddy current signal converter function within the Emerson DeltaV. The retained documentation identifies linear measurement range as 2 mm (80 mils); apply that value only to this documented execution.
Match the complete label, hardware form and functional position before transferring any setting, cable or termination from the removed unit.
Interface Review: approve PR6424/000-040 CON021 only for the documented Emerson DeltaV distributed control system. Compare rack, carrier or panel generation, connector keying, terminal numbering and all paired assemblies with the installation drawings.
Photograph both sides and the installed position before removal so revision markings, jumpers, addressing and channel allocation can be reconstructed accurately.
Site Testing: isolate the equipment, remove stored energy and inspect the receiving hardware before installing PR6424/000-040 CON021.
Restore power in the approved sequence, review status and diagnostics, then test every affected control, signal, relay, communication, protection or monitoring path against the commissioning record.
