Overview
Manuals
Probe Selection
Route Planning
Commissioning
Features:
- 8mm Eddy Current Sensor function for the documented Emerson EPRO machinery monitoring system platform.
- Linear Measurement Range: 2 mm (80 mils).
- Initial Air Gap: 0.5 mm (20 mils).
PR6423/012-130 CON021 is a Emerson 8mm eddy current sensor for the Emerson EPRO machinery monitoring system. The documented identity places it in the Emerson EPRO product family and defines its role as 8mm eddy current sensor within the installed control or monitoring architecture.
The available manufacturer-family information records linear measurement range: 2 mm (80 mils); initial air gap: 0.5 mm (20 mils); minimum shaft diameter: 25 mm (0.79”). Before replacement, compare the complete nameplate, receiving hardware, connector or terminal arrangement and approved project documentation; after installation, verify diagnostics and every affected signal or communication path before process release.
The PR6423/012-130 CON021 8mm Eddy Current Sensor is treated as Confirm Current OEM Lifecycle Status. Moore Automated may supply the exact item subject to stock, condition and complete identity verification.
Emerson PR6423/012-130 CON021 8mm Eddy Current Sensor Manual(Datasheets), Link
Important Notice: Use the exact-model manufacturer document when available. If no exact PDF is confirmed, rely on the verified product-family and model information linked within Moore Automated. Accessories, cables, calibration data and software are included only when stated in the quotation. All prices are shown in USD.
PR6423/012-130 CON021 is a Emerson 8mm eddy current sensor for the Emerson EPRO machinery monitoring system. The documented identity places it in the Emerson EPRO product family and defines its role as 8mm eddy current sensor within the installed control or monitoring architecture.
The listed parameters are limited to the documented model or product-family evidence. Do not import ratings from a similar part number; compare the exact label, slot or carrier, terminal map and connected equipment.
PR6423/012-130 CON021 must remain matched to the documented Emerson EPRO machinery monitoring system installation. Confirm the receiving hardware generation, connector or terminal arrangement, software or configuration dependencies and system drawings before approving the item.
Photograph labels and connections before removal and preserve the original position, keying, addressing and channel allocation.
Isolate the equipment using the approved procedure, verify all stored energy is removed and inspect the receiving hardware before fitting PR6423/012-130 CON021.
After installation, restore power in the documented sequence, review diagnostics and test every affected signal, relay, network, control or protection function against the commissioning record.
