Overview
Manuals
Transducer Choice
Route Planning
Commissioning
Features:
- 16mm Eddy Current Sensor for the documented Emerson EPRO eddy-current measurement system.
- Sensitivity/Linearity: 4 V/mm (101.6 mV/mil) ≤ ±1.5%.
- Air Gap (Center): Approx. 2.7 mm (0.11”) Nominal.
PR6424/006-111 CON031 is a Emerson 16mm eddy current sensor engineered for the Emerson EPRO eddy-current measurement system. It performs the documented 16mm eddy current sensor function within the Emerson EPRO PR 642x hardware architecture, so the complete order code, hardware execution and receiving position must be retained during selection.
Product-level and manufacturer-family information records sensitivity/linearity: 4 V/mm (101.6 mV/mil) ≤ ±1.5%; air gap (center): Approx. 2.7 mm (0.11”) Nominal; long term drift: < 0.3%; maximum surface speed: 2,500 m/s (98,425 ips). Before replacement, compare the installed label, rack or carrier, terminal or connector arrangement, power and signal requirements and approved configuration; after installation, verify diagnostics and every affected control, communication, safety or monitoring path before returning the equipment to service.
The PR6424/006-111 CON031 16mm Eddy Current Sensor is supplied only after the exact hardware identity, condition and current OEM lifecycle status have been confirmed.
Emerson PR6424/006-111 CON031 16mm Eddy Current Sensor manuals and technical resources.
Important Notice: The linked resources support the listed model or its identified product family. Confirm the complete order code, hardware revision and installed-system requirements before replacement. Accessories, cables, software and certificates are included only when stated in the quotation. All prices are shown in USD.
PR6424/006-111 CON031 is a Emerson 16mm eddy current sensor engineered for the Emerson EPRO eddy-current measurement system. It performs the documented 16mm eddy current sensor function within the Emerson EPRO PR 642x hardware architecture, so the complete order code, hardware execution and receiving position must be retained during selection.
The listed parameters are limited to the documented model or product-family evidence. Compare the complete label, receiving hardware, terminal map and connected equipment rather than transferring ratings from a nearby code.
PR6424/006-111 CON031 must remain matched to the documented Emerson EPRO eddy-current measurement system installation. Confirm hardware generation, slot or carrier, connector or terminal arrangement, software or configuration dependencies and system drawings before approval.
Photograph labels and connections before removal and preserve the original position, keying, addressing and channel allocation.
Isolate the equipment using the approved procedure, verify stored energy is removed and inspect the receiving hardware before fitting PR6424/006-111 CON031.
After installation, restore power in the documented sequence, review diagnostics and test every affected signal, relay, network, control, safety or monitoring function against the commissioning record.
