Overview
Manuals
Model and Identity
Link Compatibility
Service Verification
Features:
- Honeywell's November 2020 System Hints lists TC-IOLI01 as an I/O Link Interface.
- The reviewed entry does not specify ports, electrical link parameters, supported controllers or a detailed compatibility matrix.
- TK-IOLI01 is a separate model entry; physical execution and interchangeability require OEM confirmation.
Honeywell's November 2020 System Hints model list identifies TC-IOLI01 as an I/O Link Interface. That model entry establishes the product class and spelling used on this page. It does not describe the link protocol or media, connector type, number of ports, transfer rate, cabling limits or supported controller releases. The same page also lists TK-IOLI01 under a separate model code, so this listing does not assume that the two executions are interchangeable or have identical installation requirements.
Before ordering or service, compare the complete TC-IOLI01 label with the installed chassis, interface position, link hardware, cables and approved site drawings. Obtain the applicable Honeywell installation or service documentation to confirm required software releases, link topology, termination and diagnostic procedures. Record the pre-removal link state and configured controller/I/O associations. Qualified personnel should isolate or place the process in the approved state, replace the module under the site procedure, then verify communications and I/O health before returning control functions to service.
The TC-IOLI01 Honeywell I/O Link Interface may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Honeywell TC-IOLI01 official technical documentation and product links.
This multi-page Honeywell technical document contains the exact model and its technical data. Apply the values to the supplied type number and verify its revision before installation.
Honeywell lists TC-IOLI01 as an I/O Link Interface. Confirm the exact model code printed on the supplied module and in the installed equipment list. The same source separately lists TK-IOLI01, but it does not establish that the two executions can replace each other or use identical hardware, cabling or environmental arrangements.
The reviewed official model-list entry does not state supported controllers, chassis slots, link media, cable length, protocol or firmware. These requirements must be confirmed from the exact Honeywell installation and service documents for the installed system. Compare the approved topology and module position before moving or replacing any interface hardware.
Before maintenance, record controller and I/O link status, alarms and communication paths. Use the site's approved process state and qualified procedures when removing or installing a link interface. After replacement, confirm the expected module identification, link health, associated I/O availability and alarms. The reviewed model-list page does not prescribe a hot-swap or live-replacement procedure.
