Overview
Manuals
Output Assignment Check
Replacement Identification
Integration
Features:
- Binary output module identified by the complete ABB article number P70870-4-0369059.
- Designed for its documented H&B Contronic P control-system rack location.
- Selection is based on the exact rack position, terminal assignment, connector arrangement, output load and module revision.
PAB 02 provides the binary output interface required by its assigned Contronic P control configuration. The abbreviated designation must always be checked together with the full article number because compatibility depends on the installed rack and field-circuit arrangement.
Before replacement, compare the module nameplate, rack position, connectors, terminal assignment and field wiring with the plant engineering records. Do not use an unverified electrical rating or channel count for selection.
Official source: ABB / Hartmann & Braun Contronic P identification documentation for PAB 02, article P70870-4-0369059.
PAB 02 technical documentation and verified Moore Automated resources.
Important Notice: Confirm the complete model, revision and installed system before replacement.
Match the documented field circuits
Use the cabinet drawings to confirm which binary outputs are assigned to the PAB 02 position. Verify terminal numbering, connected loads and isolation requirements before removing or inserting the module.
Use the complete ABB article number
Order against PAB 02 and P70870-4-0369059, not the short family name alone. Compare the revision and physical interface shown on the installed nameplate and provide photographs when any marking is incomplete.
Restore the original control configuration
After mechanical and electrical checks, commission the replacement in accordance with the existing Contronic P engineering records. Confirm the intended output states and cabinet safety procedure before returning the controlled equipment to service.
