Overview
Manuals
DARA Assembly
Feedback Connections
Signal Wiring Checks
Features:
- ABB ASTAT internal board identified in the official DARA cabinet mounting arrangement.
- X1-X4 connector references used for the documented active rotor-feedback motor selection.
- Installed signal environment covering digital input, PTC, analog I/O and pulse-encoder circuits.
DATX130, alternate marking 3ASC25H214, must remain matched to the exact ASTAT execution, DARA cabinet and connector map. Retain the original wiring record before board service.
Official source: ABB ASTAT Manual 3BSE017422R0008 identifies DATX130 in the DARA layout and documents the related feedback, PTC, analog, digital and encoder connections.
DATX130 technical documentation and verified Moore Automated resources.
Important Notice: Confirm the complete model, revision and installed system before replacement.
ABB places DATX130 on the upper section of the DARA hinged mounting sheet, with DASA110 and DATX110 in the same documented assembly. The cabinet execution and board positions should be recorded before disassembly.
Use ESD controls and the site isolation procedure when accessing the mounting sheet. Do not treat DATX130 as a stand-alone field module outside the ASTAT cabinet arrangement.
ABB documentation links connectors DATX130-X1 through X4 to the selected motor used for active rotor-speed feedback. The project parameter determines which motor and connector are active.
Label each plug and confirm the recorded rotor-feedback selection before replacement. An incorrect connector assignment can disconnect the intended speed-feedback path.
The related DARA cable area carries digital inputs, PTC, analog inputs, analog outputs and pulse-encoder wiring. Screened cables should remain secured by the documented clamps and cable routes.
After replacement, check connector seating, PTC status, encoder feedback and the expected analog and digital signals under the approved ASTAT commissioning procedure.
