Overview
Manuals
Code Verification
Board Interface
Service Evidence
Features:
- The documented product type is Analog Interface Conversion Board, and this value must match the supplied unit.
- The documented category series is UNITROL Excitation Systems, and this value must match the supplied unit.
- The documented voltage supply is 24 V DC, and this value must match the supplied unit.
ABB HIEE300725R1 UAC317AE V1 is a Analog Interface Conversion Board documented for the applicable UNITROL Excitation Systems system configuration. Its recorded specification includes product type Analog Interface Conversion Board, category series UNITROL Excitation Systems, voltage supply 24 V DC. Correct selection depends on the complete article identity, installed equipment, mechanical or electrical interfaces and the documented configuration rather than appearance alone. Using the exact model helps maintenance teams avoid incompatible revisions, connector arrangements and application variants.
Before installing HIEE300725R1 UAC317AE V1, record the original nameplate, installed position, connected assemblies and every relevant configuration detail. Compare the supplied unit with the existing hardware and applicable ABB service documentation, isolate all affected energy sources and preserve required settings or calibration data. After installation, inspect each affected interface and complete controlled functional checks before returning the equipment to service.
The HIEE300725R1 UAC317AE V1 ABB Analog Interface Conversion Board is listed as Active / Available from OEM. Current revision, availability and supplied scope are confirmed in the written quotation.
ABB HIEE300725R1 UAC317AE V1 documentation and reference links.
Important Notice: Every linked document must identify the listed model or its documented family. Confirm the complete order code, hardware revision and installed-system requirements before replacement.
no exact ABB product sheet was located that prints HIEE300725R1 and UAC317AE V1 together with electrical ratings. Apply only to the complete HIEE300725R1 UAC317AE V1 identity.
Before connection, match the complete board marking, connector layout, installed slot, harness and UNITROL drawing set.
Document the installed state, then compare I/O behavior against the recorded board and stop if any label or connector differs.
