Overview
Manuals
Remote Cnet
Dual Serial
INIIR01 Fit
Features:
- The documented module function is Cnet-to-Cnet remote transfer, and this value must match the supplied unit.
- The documented remote interface assembly is INIIR01 with INNIS01 and INIIT12, and this value must match the supplied unit.
- The documented serial interfaces is Two RS-232-C ports, and this value must match the supplied unit.
ABB INIIT12 is a Cnet-to-Cnet Remote Transfer Module documented for the applicable Bailey Infi 90 system configuration. Its recorded specification includes module function Cnet-to-Cnet remote transfer, remote interface assembly INIIR01 with INNIS01 and INIIT12, serial interfaces Two RS-232-C ports. Correct selection depends on the complete article identity, installed equipment, mechanical or electrical interfaces and the documented configuration rather than appearance alone. Using the exact model helps maintenance teams avoid incompatible revisions, connector arrangements and application variants.
Before installing INIIT12, record the original nameplate, installed position, connected assemblies and every relevant configuration detail. Compare the supplied unit with the existing hardware and applicable ABB service documentation, isolate all affected energy sources and preserve required settings or calibration data. After installation, inspect each affected interface and complete controlled functional checks before returning the equipment to service.
The INIIT12 ABB Cnet-to-Cnet Remote Transfer Module is listed as Active / Available from OEM. Current revision, availability and supplied scope are confirmed in the written quotation.
ABB INIIT12 documentation and reference links.
Important Notice: Every linked document must identify the listed model or its documented family. Confirm the complete order code, hardware revision and installed-system requirements before replacement.
ABB lists two RS-232-C ports, selectable rates to 19.2 kbaud, 256 kB ROM, 512 kB RAM and 256 kB NVRAM. Apply only to the complete INIIT12 identity.
Before connection, match an INNIS01 network interface and NTMP01 termination hardware.
Document the installed state, then verify both serial ports, network status and the intended redundant arrangement.
