Overview
Manuals
Custom Code Control
Electrical-Length Match
Flexible Probe Setup
Features:
- The 162381 prefix identifies a custom flexible 3/8-24 probe whose drawing-specific suffix must be retained without abbreviation.
- The complete order code carries a 5.0 m total-length block and the manufacturer-documented 05 approval suffix.
- The probe uses the 3300 XL 8 mm platform’s nominal 7.87 V/mm scale and 2.0 mm range when matched to the correct system components.
Bently Nevada lists 162381-064-028-50-05 under the 162381 custom flexible 3300 XL 8 mm probe family. The manufacturer approval reference identifies 162381 as a 3/8-24 flexible probe configuration, while the complete suffix preserves the special mechanical identity, the 5.0 m total-length block and approval option 05. Its electrical behavior follows the 3300 XL 8 mm platform, including the nominal 200 mV/mil scale and 2.0 mm linear range when paired with the correct Proximitor Sensor and target material. Because the first custom suffix blocks are drawing-specific, they must be copied exactly from the original label or manufacturer record rather than interpreted as a standard 330101 mechanical code. A valid replacement therefore requires the complete 162381 number, installed geometry, cable route, connector and electronics length to be compared together.
Manufacturer reference: official 3300 XL 8 mm custom flexible probe documentation.
Moore Automated supports exact-item verification and spare-part enquiries for 162381-064-028-50-05.
Bently Nevada 162381-064-028-50-05 Flexible 8 mm proximity probe manual (Datasheet), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Preserve every suffix block from the original label or drawing; do not map the custom 162381 geometry to a standard probe table.
Confirm the 5.0 m total-length block and match it to the installed 3300 XL 8 mm Proximitor Sensor arrangement.
Verify the 3/8-24 mounting path, cable bend radius, target clearance and live gap voltage before locking the probe position.
