Overview
Manuals
Probe Configuration
System Compatibility
Gap & Installation
Features:
- The documented value for unthreaded length is 0 mm; confirm the installed mounting interface, available reach and mechanical.
- The documented value for overall case length is 80 mm; retain this dimension when checking mounting geometry, routing.
- The documented value for total length is 1.0 meter (3.3 feet); retain this dimension when checking mounting geometry.
330104-00-08-10-02-05 is a Bently Nevada 3300 XL 8 mm proximity probe used as one element of a matched proximity-transducer system. With a compatible extension cable and Proximitor Sensor, the system converts the gap between the probe tip and a conductive shaft surface into an output proportional to displacement. The configured monitor can use that signal for static shaft position or dynamic vibration measurement, and for speed or Keyphasor reference functions where the full signal chain supports them. For this complete order code, verify the mounting geometry, cable length, connector, approval markings and receiving monitor against the installed nameplate before replacement; appearance or a matching base family alone does not establish interchangeability.
The transducer output depends on the complete probe, extension cable, Proximitor Sensor and configured monitor. Check the nameplate, installed cable routing, probe gap and commissioning baseline before returning the measurement channel to service. The reviewed manufacturer document describes the 3300 XL 8 mm proximity-transducer family. A lifecycle status specific to the complete order code 330104-00-08-10-02-05 was not established from the reviewed source; confirm current OEM orderability at quotation.
The 330104-00-08-10-02-05 may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
330104-00-08-10-02-05 documentation and reference links.
Important Notice: Confirm the complete catalog identity, hardware revision, receiving-system configuration and required document revision before replacement.
Preserve every option block of 330104-00-08-10-02-05. Retained facts: Unthreaded Length: 0 mm; Overall Case Length: 80 mm; Total Length: 1.0 meter (3.3 feet). Mechanical length, thread, cable/connector and approval suffixes are part of the exact probe identity.
Match probe family, electrical length, extension cable and Proximitor Sensor. Confirm target material, available travel, nearby probe spacing and mounting geometry before exchange.
Set the operating gap from live bias voltage, support the cable above its bend limit and verify runout, vibration or position response against the commissioning baseline.
