Overview
Manuals
Mounting Parameters
System Compatibility
Signal Interaction
Features:
- Provides the specified metric threaded configuration for compatible machinery installations.
- Uses a 1.0 m probe with flexible stainless-steel armor and an FEP outer jacket.
- Supports a 2 mm linear range with a nominal 7.87 V/mm scale factor.
The Bently Nevada 330104-00-10-10-02-00 is a 3300 XL 8 mm Proximity Probe designed for non-contact measurement of machinery shaft position and vibration. The exact configuration uses an M10 × 1 thread, a 0.0 in unthreaded length, a 1.0 in overall case length, a 1.0 m total probe length, a miniature coaxial ClickLoc connector, and standard cable. The probe is equipped with flexible stainless-steel armor for the cable assembly.
As a component of the 3300 XL 8 mm system, the probe works with a compatible extension cable and Proximitor Sensor to provide a proportional output related to the distance between the probe tip and conductive target. Bently Nevada specifies a nominal 7.87 V/mm (200 mV/mil) scale factor and a 2 mm (80 mil) linear range for the standard 3300 XL 8 mm system. The system is intended for vibration and position measurements on fluid-film bearing machines and can also support Keyphasor reference and speed measurements when the complete system is configured appropriately.
The 330104-00-10-10-02-00 Bently Nevada 3300 XL 8 mm Proximity Probes may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Bently Nevada 330104-00-10-10-02-00 3300 XL 8 mm Proximity Probes Manuals(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
The exact 330104 configuration uses an M10 × 1 probe thread. The OEM specifies a maximum M10 × 1 thread engagement of 15 mm. For standard forward-mounted probes, the recommended case torque is 11.2 N·m (100 in-lbf) and the maximum rated torque is 33.9 N·m (300 in-lbf).
The probe is intended to operate with compatible 3300 XL 8 mm extension cables and Proximitor Sensors. Bently Nevada states that 3300 XL 8 mm components are electrically and physically interchangeable with non-XL 3300 5 mm and 8 mm components when the specified mechanical constraints, including cable bend radius, are observed. Mixing XL and non-XL components, however, can limit system performance to the applicable non-XL specifications.
For installations using multiple proximity systems, Bently Nevada recommends maintaining adequate separation between probe tips to control cross-talk. The manufacturer generally recommends at least 40 mm axial separation for axial-position measurements or 38 mm radial separation for radial-vibration measurements under the specified conditions.
