Overview
Manuals
Case Reach
System Match
Shaft Checks
Features:
- The complete order code identifies a M10 x 1 armored proximity probe with 0 mm unthreaded length and 180 mm overall case length.
- A 1.0 m (3.3 ft) total probe lead terminates in a armored standard ClickLoc cable without a connector protector for the documented 3300 XL measurement chain.
- Published 7.87 V/mm scale factor, 2 mm linear range and 0-10 kHz response apply to a compatible matched transducer system.
330104-00-18-10-02-00 is a Bently Nevada M10 x 1 armored proximity probe in the 3300 XL 8 mm family. The official ordering code specifies 0 mm unthreaded length, 180 mm overall case length, 1.0 m (3.3 ft) total probe length and a armored standard ClickLoc cable without a connector protector; each field must match the installed mechanical arrangement.
The probe is one element of a matched eddy-current transducer chain. Before replacement, document the gap, target material, mounting depth, cable routing, connector condition, extension-cable arrangement, Proximitor Sensor and monitor settings, then verify bias voltage and machine response after installation.
The manufacturer classifies this legacy product family as obsolete or discontinued. Moore Automated may still supply the exact item subject to stock, condition and complete identity verification.
Bently Nevada 330104-00-18-10-02-00 Proximity Probe Manual(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
330104-00-18-10-02-00 is a M10 x 1 standard-mount probe with stainless-steel armor in the 3300 XL 8 mm family. Its order code specifies 0 mm unthreaded length, 180 mm case length, 1.0 m (3.3 ft) total probe length and miniature coaxial clickloc; standard cable; no protector.
The order-code fields must be read together. Confirm M10 x 1 mounting, 180 mm case definition, 1.0 m (3.3 ft) total cable length and the exact connector option.
The probe, extension cable and Proximitor Sensor must form the documented total system length. Published performance applies to compatible components and the specified target material under official test conditions.
Do not approve a substitution from appearance alone. Compare every connected part number, cable route, target, monitor-channel setup and calibration record.
Before removal, record the installed gap, mounting depth, cable routing, connector condition, Proximitor Sensor identity and channel settings.
After installation, verify bias voltage, slow-roll runout, vibration response and alarm-channel behavior before returning the machine to service.
