Overview
Manuals
Proximitor Setup
Cable-system fit
Startup Check
Features:
- 330180-50-05 is identified by system length 5.0 m within the documented 3300 XL 8 mm proximity transducer system configuration.
- The official specification gives mounting option as Panel mount, which must be retained during selection.
- Commissioning must also preserve approval option (CSA, ATEX and IECEx, code 05) and the stated connection limits.
A panel-mount 3300 XL Proximitor Sensor calibrated for a 5.0 m total 8 mm transducer-system length. It powers the probe, conditions the eddy-current signal and provides voltage proportional to probe-to-target gap; code 05 identifies the multiple-approval option. Selection must preserve the complete label identity, connected-equipment compatibility and manufacturer installation limits.
Manufacturer reference: official 3300 XL 8 mm proximity transducer system documentation.
Moore Automated supports exact-item verification and spare-part enquiries for 330180-50-05.
Bently Nevada 330180-50-05 official manufacturer document excerpt (PDF), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Confirm the complete 330180-50-05 identity and compare system length, mounting option and approval option with the installed design before approving a replacement.
Probe lead and extension cable must add to exactly 5.0 m and both must belong to the 3300 XL 8 mm family. NSv, 5 mm, 11 mm and 9.0 m components use different calibrations.
Mount the Proximitor on an isolated panel, preserve shield and common wiring, connect the matched 5.0 m probe chain, set the mechanical gap and confirm output scale and alarm-channel polarity.
