Overview
Manuals
Body Mounting
Cable Protection
System Commissioning
Features:
- 3300 XL 25 mm proximity probe with smooth 1.06 inch side-exit body for a documented clamp-mounted installation.
- Complete code defines 0.0 inch unthreaded length, 4.0 inch overall case length and 1.0 m total cable length.
- Stainless-steel cable armor protects the lead while the matched 25 mm extension cable and Proximitor sensor maintain the specified transducer chain.
330851-04-000-040-10-01-00 Bently Nevada 330851-04-000-040-10-01-00 is a 3300 XL 25 mm proximity probe for a documented non-contact machinery-measurement chain. Its complete code selects a smooth 1.06 inch side-exit body, 0.0 inch unthreaded length, 4.0 inch overall case length, 1.0 m total length, stainless-steel cable armor and no agency-approval option. Correct operation depends on the specified 25 mm extension cable and Proximitor sensor, suitable target geometry, secure smooth-body mounting and accurate probe-gap setup.
Official source: Bently Nevada 3300 XL 25 mm Proximity Transducer System Datasheet 163236. Ordering-code selections and matched-system requirements must be verified for the installed channel.
330851-04-000-040-10-01-00 technical documentation and verified Moore Automated resources.
Important Notice: Match the probe, extension cable and 25 mm Proximitor sensor as one system.
The smooth 1.06 inch probe body requires the approved clamp arrangement and enough side clearance for the cable exit. Verify the 4.0 inch case position and target alignment before locking the probe.
Route the 1.0 m stainless-steel armored lead without exceeding the permitted bend or stressing the side exit. Inspect armor, connector and cable support before commissioning.
Connect only to the matched 3300 XL 25 mm extension cable and Proximitor sensor. Set the probe gap, verify channel response and document the final mechanical and electrical configuration.
