Overview
Manuals
Compatibility Checks
Installation Planning
Configuration Reference
Features:
- 3300 XL 8 mm identity: 330101-00-18-10-02-05 belongs to the documented 3300 XL 8 mm family.
- Configuration: unthreaded length 00, case length 18 (1.8 in), total length 10 (1.0 m), ClickLoc connector with protector and standard cable option 02, approval option 05.
- Verification focus: Confirm all 00-18-10-02-05 suffixes and the matched extension-cable/Proximitor total length before replacement.
Bently Nevada 330101-00-18-10-02-05 is 3/8-24 unf proximity probe without armor designed for Bently Nevada 3300 XL 8 mm proximity transducer systems. According to the manufacturer documentation, it works with a matched extension cable and Proximitor Sensor to measure shaft vibration and position without contact. The ordering code identifies all 00-18-10-02-05 suffixes and the matched extension-cable/Proximitor total length, so the complete nameplate information should be reviewed whenever the item is being selected for a maintenance replacement, a system extension, or a spare-parts holding.
The technical content for 330101-00-18-10-02-05 is limited to the manufacturer product page and the cited official datasheet or manual. Final compatibility depends on the 3300 XL 8 mm extension cable, Proximitor Sensor, total electrical length, thread, target material, and approval option.
The Bently Nevada 330101-00-18-10-02-05 3/8-24 UNF proximity probe without armor is supported by Moore Automated for verified industrial replacement and spare-part requirements.
Bently Nevada 330101-00-18-10-02-05 3/8-24 UNF proximity probe without armor manual(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Compatibility Checks
Confirm the 3300 XL 8 mm extension cable, Proximitor Sensor, total electrical length, thread, target material, and approval option. The complete 330101-00-18-10-02-05 marking and nameplate data should be compared with the installed item before a purchase order is released.
Installation Planning
Follow the manufacturer instructions and verify probe gap, 3/8-24 thread engagement, cable routing, connector protector, and total system length. Accessories, connectors, cables, sockets, or terminal blocks must be ordered separately unless the quotation lists them.
Configuration Reference
unthreaded length 00, case length 18 (1.8 in), total length 10 (1.0 m), ClickLoc connector with protector and standard cable option 02, approval option 05. Use the official ordering information to confirm every suffix, revision, and option that applies to the required unit.
