Overview
Manuals
Compatibility Checks
Installation Planning
Configuration Reference
Features:
- legacy 25 mm proximity probe identity: 86497-01-02-02-00 belongs to the documented legacy 25 mm proximity probe family.
- Configuration: legacy 86497 ordering code; current official 3300 XL 25 mm documentation is used only as a replacement-series reference, not as an identical part-number claim.
- Verification focus: Confirm the complete 86497-01-02-02-00 suffix, probe tip size, cable length, connector, thread, and installed Proximitor before replacement.
Bently Nevada 86497-01-02-02-00 is legacy large-tip proximity probe configuration designed for Bently Nevada proximity measurement installations. According to the manufacturer documentation, it provides non-contact displacement measurement in large linear-range applications. The ordering code identifies the complete 86497-01-02-02-00 suffix, probe tip size, cable length, connector, thread, and installed Proximitor, so the complete nameplate information should be reviewed whenever the item is being selected for a maintenance replacement, a system extension, or a spare-parts holding.
The technical content for 86497-01-02-02-00 is limited to the manufacturer product page and the cited official datasheet or manual. Final compatibility depends on the original 7200/25 mm probe system, target material, total electrical length, connector, and Proximitor calibration.
The Bently Nevada 86497-01-02-02-00 legacy large-tip proximity probe configuration is supported by Moore Automated for verified industrial replacement and spare-part requirements.
Bently Nevada 86497-01-02-02-00 legacy large-tip proximity probe configuration manual(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Compatibility Checks
Confirm the original 7200/25 mm probe system, target material, total electrical length, connector, and Proximitor calibration. The complete 86497-01-02-02-00 marking and nameplate data should be compared with the installed item before a purchase order is released.
Installation Planning
Follow the manufacturer instructions and verify mechanical gap, probe thread and case, cable routing, target size, and matched transducer system. Accessories, connectors, cables, sockets, or terminal blocks must be ordered separately unless the quotation lists them.
Configuration Reference
legacy 86497 ordering code; current official 3300 XL 25 mm documentation is used only as a replacement-series reference, not as an identical part-number claim. Use the official ordering information to confirm every suffix, revision, and option that applies to the required unit.
