Overview
Manuals
Processor Memory
CTNet Communications
IO Commissioning
Features:
- Dedicated processor for real-time drive and process application tasks.
- RS-485 serial communications plus CTNet high-speed drive networking.
- Two 24 V digital inputs and two 24 V digital outputs for high-speed functions.
SM-APPLICATIONS runs a downloaded drive application independently of the host drive control loop and exchanges parameters with the drive and connected devices. The official guide documents task-based programming, serial protocols and CTNet networking.
Before removal, archive the SYPTPro project and record host drive type, slot, module firmware, CTNet node, serial settings and high-speed I/O wiring. After installation, restore only the verified application and prove network, I/O and controlled machine functions.
The Emerson SM-APPLICATIONS Programmable Application Module is listed as Obsolete / Discontinued by OEM. Current revision, availability and supplied scope are confirmed in the written quotation.
Emerson SM-APPLICATIONS Product Pages, Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
The module uses a dedicated high-speed processor with 384 kB Flash for the user program and 80 kB user program memory, allowing deterministic task-based control separate from the host drive control processor.
Program compatibility depends on the module type and firmware. Preserve the original project, compile settings and module revision before replacement.
CTNet provides peer-to-peer drive networking at rates up to 5 Mbit/s. The EIA-RS485 port supports documented ANSI, Modbus-RTU slave/master and Modbus-ASCII slave/master operation.
Record CTNet node addressing, baud rate, termination, serial protocol and mapping before removal. Restore only the approved network configuration.
The module provides two 24 V digital inputs and two 24 V digital outputs for high-speed functions. Confirm signal voltage, polarity, common and project allocation from the installed design.
After installation, confirm module status, download the verified project, prove each mapped input and output, then test controlled drive and machine sequences under the approved commissioning procedure.
