Overview
Manuals
Identity Evidence
Order Controls
Technical Boundary
Features:
- Exact listed identity: DS200TCPDG1BEC
- Documented hardware type: Printed Circuit Board
- Receiving product platform: GE Mark V and Mark VI Turbine Controls
Product description:
DS200TCPDG1BEC is a General Electric printed circuit board associated with the GE Mark V and Mark VI Turbine Controls platform. It supports the documented control, interface or signal-processing duty assigned to its installed board position. Correct selection depends on the complete model code, connector or terminal arrangement, hardware revision and receiving-system configuration. Before replacement, compare the original product label, installed slot or cabinet reference, connected assemblies and approved project records. After installation, review system diagnostics and function-test every affected channel, control path, protection function or communication link before returning the equipment to service.
Selection and installation:
Use DS200TCPDG1BEC only where the installed equipment record identifies the same printed circuit board and GE Mark V and Mark VI Turbine Controls receiving platform. Confirm mechanical fit, keying, field wiring, power requirements, firmware or logic dependencies and any paired carrier or terminal assembly. Do not treat a visually similar unit or a shortened model code as proof of interchangeability.
Verification before service:
Record the supplied DS200TCPDG1BEC label, installed position and test results. Release the equipment only after the affected control and safety functions operate as required.
General Electric DS200TCPDG1BEC documentation and reference links.
Important Notice: The linked information must identify the listed model or its documented family. Confirm the complete order code, hardware revision and installed-system requirements before replacement.
Verify that the supplied item is marked DS200TCPDG1BEC and that its printed circuit board form, connectors and revision agree with the approved GE Mark V and Mark VI Turbine Controls receiving record.
For DS200TCPDG1BEC, state the required condition, quantity, installed position, connected assemblies and document requirements in the written enquiry.
Apply only parameters supported by the exact DS200TCPDG1BEC record or a documented family source. Do not infer electrical ratings or interchangeability from appearance.
