Overview
Manuals
I/O Architecture
Wiring Coordination
Module Selection Notes
Features:
- SITOP PSU300S/3AC/24VDC/10A
- SITOP PSU300S 24 V/10 A stabilized
- Power supply input: 400-500 V 3 AC output: 24 V DC/10 A
The Siemens 6EP1434-2BA20 is a sitop psu300s regulated power supply in the Siemens SITOP. The manufacturer specifies it converts a 3-phase 400-500 V AC input to a regulated 24 V DC output rated at 10 A. The DIN-rail unit provides electronic short-circuit and overload protection for industrial control circuits. Its ordering identity combines 6EP1434-2BA20 with 6EP1434-2BA20; both references should be checked when selecting a replacement. Engineering confirmation should also cover 3-phase input range, 24 V load current, DIN-rail space, conductor size and protective device and the installed base or terminal hardware before the unit is placed into service.
Values are based on the manufacturer's official Siemens SITOP documentation. Final selection must be verified against the complete article number and installed configuration.
The Siemens 6EP1434-2BA20 SITOP PSU300S regulated power supply is supported by Moore Automated for verified industrial replacement and spare-part requirements.
Siemens 6EP1434-2BA20 SITOP PSU300S regulated power supply manual(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
6EP1434-2BA20 should be engineered using the official Siemens SITOP documentation, with the stated 24 V DC / 10 A output matched to the configured signal path.
Before installation, confirm 3-phase input range, 24 V load current, DIN-rail space, conductor size and protective device, the associated base or terminal hardware, and the field-side electrical conditions shown in the manufacturer's instructions.
Use the complete article number when comparing units. Channel configuration, connected equipment and any safety or communication requirements must remain consistent with the verified design.
