Overview
Manuals
Current Input Wiring
Signal Filtering
Input Fault Diagnosis
Features:
- Two current channels: Accepts ±20 mA or 4–20 mA signals from four-wire transmitters, with 50 ohm input resistance.
- Configurable acquisition: Integrating conversion supports 16.7 ms or 20 ms integration and four smoothing settings.
- Defined diagnostic scope: Provides an SF group-fault LED and wire-break diagnosis for the 4–20 mA range.
The module transfers measured current values into an ET 200S automation project; it does not provide a 24 V, 5 A power output. Its four-byte input address space and common electrical references must be considered when designing the station and assigning controller data.
For maintenance, match the complete 6ES7134-4GB11-0AB0 order number, the installed terminal module and the configured measuring range. A replacement with different channel isolation, transmitter connection or conversion timing can require wiring and project changes even if its physical width appears similar.
Siemens lists 6ES7134-4GB11-0AB0 as PM410, product cancellation from 1 October 2023; the current data sheet identifies it as a spare part. Moore Automated can support replacement sourcing subject to exact-item, condition and stock confirmation.
Siemens 6ES7134-4GB11-0AB0 product data sheet Manual(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Range and wiring
Two current inputs support ±20 mA or 4–20 mA for four-wire transmitters. Each input is specified at 50 ohms. Check the transmitter supply and reference wiring; the two channels are not galvanically isolated from each other or from L+.
Conversion and smoothing
Siemens specifies integrating conversion with selectable 16.7 ms or 20 ms integration and 50 Hz or 60 Hz interference suppression. Smoothing can use 1, 4, 32 or 64 module cycles. Longer smoothing improves averaging but changes the response to a process step.
Evaluate faults in context
The module provides an SF group-fault LED and overflow or underflow diagnosis. Wire-break diagnosis applies to the 4–20 mA range. Check the controller's diagnostic message and the field loop together instead of treating the LED alone as a complete fault diagnosis.
