Overview
Manuals
Complete Execution
Pneumatic Installation
Loop Acceptance
Features:
- ABB ordering code V18345-1010551001 identifies a TZIDC digital electropneumatic positioner whose mechanical and option execution is defined by the complete code.
- Confirm V18345-1010551001 in full, valve and actuator identity, travel, mounting kit, air connections, 4–20 mA loop, option wiring and approval requirements.
- Use the positioner only with the documented valve assembly and control loop selected for this exact ordering-code execution.
V18345-1010551001 must be matched to the receiving equipment and project record. Inspect the mounting parts, set linkage geometry, connect clean instrument air and the two-wire signal, and preserve the documented enclosure and cable-entry arrangement. Perform autoadjust and prove travel direction, end points, 4–20 mA response, feedback, alarms and fail action under the approved valve procedure.
Official source: official ABB TZIDC data sheet PDF. Values not tied to the exact official source are withheld.
V18345-1010551001 official technical documentation and verified Moore Automated resources.
Important Notice: Confirm the complete model, article number and installed configuration before replacement. All links open in a new page.
Use V18345-1010551001 as the controlled configuration identity.
Check supply quality, fittings, actuator action and linkage geometry.
Verify current response, feedback, alarms, travel and fail action.
