Registered Address: 32D Floor Guomao Building, No.388, Hubin South Road, Siming District, Xiamen,Fujian, China
The GE Fanuc Automation IC695CPE330 is a PACSystem RX3i controller. This controller features 64MB of RAM and 64MB of non-volatile user memory, along with a 1 GHz processor. It has two independent 10/100/1000 Gbps Ethernet ports and a USB host port with a built-in switch provided via LAN 2 connectivity. The controller supports hot-standby configuration with PROFINET controllers, Ethernet (EGD), and Genius IO.
Verify that the supplied item is marked IC695CPE330 and that its cpu module form, connectors and revision agree with the approved PACSystems RX3i receiving record.
For IC695CPE330, state the required condition, quantity, installed position, connected assemblies and document requirements in the written enquiry.
Apply only parameters supported by the exact IC695CPE330 record or a documented family source. Do not infer electrical ratings or interchangeability from appearance.
IC695CPE330 technical scope: Product Line: RX3i PacSystem; Product Type: CPU controller; Processor Clock Speed: 1.0 Ghz; RAM: 64 MB; NVRAM: 64MB.
Use these values only for the listed hardware execution and verify the supplied label before installation.
Match IC695CPE330 to the approved PACSystems RX3i receiving position, connector or terminal arrangement and configuration record.
After power restoration, review diagnostics and test the affected cpu module path.
Active / Available from OEM
IC695CPE330 is a General Electric cpu module associated with the PACSystems RX3i platform. It supports the documented controller execution, communications and configuration functions assigned to the installed processor position. Correct selection depends on the complete model code, connector or terminal arrangement, hardware revision and receiving-system configuration. Before replacement, compare the original product label, installed slot or cabinet reference, connected assemblies and approved project records. After installation, review system diagnostics and function-test every affected channel, control path, protection function or communication link before returning the equipment to service.