Registered Address: 32D Floor Guomao Building, No.388, Hubin South Road, Siming District, Xiamen,Fujian, China
The General Electric IC698PSA350E is a power supply module for PACSystems RX7i industrial automation applications. Documented product details include PACSystems Power Supply Module; GE Fanuc for the RX7i series; This module sends logic level sequencing; signals to modules on the backplane. Confirm the complete model code, hardware revision and supplied condition against the installed equipment before replacement.
Verify that the supplied item is marked IC698PSA350E and that its power supply module form, connectors and revision agree with the approved PACSystems RX7i receiving record.
For IC698PSA350E, state the required condition, quantity, installed position, connected assemblies and document requirements in the written enquiry.
Apply only parameters supported by the exact IC698PSA350E record or a documented family source. Do not infer electrical ratings or interchangeability from appearance.
IC698PSA350E technical scope: Category Series: PACSystems RX7i series; Product Type: Power Supply; Input Power: 437 W; Output Voltages: + 5 VDC, +12 VDC or -12VDC; Input Voltage Range: 85 to 264 VAC or 100 to 150 VDC.
Use these values only for the listed hardware execution and verify the supplied label before installation.
Match IC698PSA350E to the approved PACSystems RX7i receiving position, connector or terminal arrangement and configuration record.
After power restoration, review diagnostics and test the affected power supply module path.
Obsolete/Discontinued by OEM
IC698PSA350E is a General Electric power supply module associated with the PACSystems RX7i platform. It supports the documented power-conversion and distribution duty assigned to the installed rack or cabinet position. Correct selection depends on the complete model code, connector or terminal arrangement, hardware revision and receiving-system configuration. Before replacement, compare the original product label, installed slot or cabinet reference, connected assemblies and approved project records. After installation, review system diagnostics and function-test every affected channel, control path, protection function or communication link before returning the equipment to service.