Overview
Manuals
AC Supply Identity
Combined Load Budget
Mounting and Service
Features:
- Honeywell table 5-1 identifies TK-FPCXX2 as the coated AC standard supply.
- Selectable input spans 85-132 or 170-265 VAC at 47-63 Hz.
- Maximum total output is 70 W at 60 °C across the combined backplane rails.
Honeywell's Series-A power table distinguishes uncoated TC-FPCXX2 from coated TK-FPCXX2, and AC FPCXX2 from DC FPDXX2. The TK-FPCXX2 AC column specifies selectable 85-132 or 170-265 VAC input, 47-63 Hz, 150 VA/92 W input power and 15 A maximum inrush. The four backplane rail current maxima are 1.5 A at 1.2 V, 4 A at 3.3 V, 10 A at 5.1 V and 2.8 A at 24 V. These individual maxima cannot all be consumed without regard to the shared 70 W maximum output at 60 °C. Module mix and temperature must be considered together.
For replacement, qualified personnel should record the installed supply's full TK-FPCXX2 marking, selected AC input range, wiring, chassis type and connected module load. Follow the Honeywell installation guide and site lockout, discharge and electrostatic precautions. The table lists left-side chassis mounting without consuming a slot, a non-replaceable soldered fuse, #14 AWG wiring and approximately 1.1 kg unit mass; the mass is not a packed shipping weight. After fitting the approved part, verify input selection, output rails, chassis diagnostics and all affected controller and I/O functions under the site's commissioning plan. The reviewed specification does not state current Honeywell support or authorization for energized replacement.
The TK-FPCXX2 Honeywell Coated Series-A AC Power Supply may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Honeywell TK-FPCXX2 official technical documentation and product links.
This multi-page Honeywell technical document contains the exact model and its technical data. Apply the values to the supplied type number and verify its revision before installation.
Honeywell table 5-1 names TK-FPCXX2 as the coated standard non-redundant Series-A AC supply. The neighboring TK-FPDXX2 is a DC-input supply, while TC-FPCXX2 is the uncoated AC variant. These model designations should not be collapsed into one generic power module. Confirm the complete physical label, input source, coating requirement and chassis against the approved bill of materials.
The manufacturer specifies selectable 85-132 or 170-265 VAC input and 47-63 Hz frequency, with a 15 A maximum inrush. Backplane rail current maxima are listed separately, but footnote 3 limits combined power from all rails to 70 W. Review the installed module mix and temperature rather than treating each rail maximum as independently available at full load.
The table places the supply on the left side of the Series-A chassis without consuming a module slot. It describes a soldered, non-replaceable fuse, #14 AWG wiring and an approximate unit mass of 1.1 kg. Follow Honeywell's release-specific replacement instructions and site electrical-isolation rules. After work, check input setting, rail voltages, alarms and affected I/O; the 2012 table alone does not establish current lifecycle.
