Overview
Manuals
Relay Contact Ratings
Terminal Module and Wiring
Substitute Value and Diagnostics
Features:
- Two normally open relay outputs in a 15 mm ET 200S electronic module.
- Switches documented 24 to 120 VDC or 24 to 230 VAC loads up to 5 A.
- Supports substitute-value output and SF group-fault indication.
The exact article identifies the two-relay normally open execution. Terminal module, load voltage, contact duty, protection, wiring and control parameters must match the installed ET 200S station.
Record the full label, terminal-module code, slot, load voltage, load type, field wiring, fuse protection, substitute-value behavior and diagnostics. After replacement, test both relay outputs under controlled conditions and verify every affected permissive and interlock.
The 6ES7132-4HB01-0AB0 Siemens ET 200S 2RO relay digital output module is listed as Obsolete / Discontinued by OEM. Current revision, availability and supplied scope are confirmed in the written quotation.
Siemens 6ES7132-4HB01-0AB0 documentation and reference links.
Important Notice: Confirm the complete order identity, hardware execution, receiving-system configuration and required document revision before replacement.
Confirm the 24 to 120 VDC or 24 to 230 VAC load class, 5 A limit, contact duty, external protection and inrush current for each channel.
Preserve the approved ET 200S terminal module, channel conductors, commons, protective devices and field-circuit isolation.
Restore the configured substitute-value response and verify SF indication, controller diagnostics and both commanded output states.
