Overview
Manuals
Use Cases
Technical Specifications
Configuration Notes
Features:
- 7200 Series 5 mm standard-mount probe.
- 1/4-28 UNF threaded case without lead armor.
- 0.0-inch unthreaded length, 2.8-inch case and 1.0-metre lead.
Configured 7200 Series 5 mm standard-mount proximity probe for non-contact shaft vibration and position measurement in a matched legacy transducer system. The complete catalog identity must remain associated with the installed sensor chain, mounting hardware, extension cable or receiving monitor as applicable.
Before replacement, record the complete label, installed position, connector and cable route, mechanical setting, gap or mounting reference and receiving-channel configuration. After installation, verify the signal, diagnostics and every affected protection or monitoring function under the approved site procedure.
The 21500-00-28-10-02 Bently Nevada 7200 Series 5 mm Proximity Probe is listed as Obsolete / Discontinued by OEM. Current revision, availability and supplied scope are confirmed in the written quotation.
21500-00-28-10-02 Bently Nevada product manual and reference links.
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
21500-00-28-10-02 is used in qualified rotating-equipment monitoring and protection installations where its complete mechanical and electrical execution matches the approved design.
Typical industry use includes power generation, oil and gas, petrochemical processing and water or wastewater machinery. Application similarity alone does not establish compatibility.
The exact 21500-00-28-10-02 configuration is identified by its complete order code. Verified technical values recorded for this item include Probe diameter: 5 mm; Mounting configuration: Standard mount; Case thread: 1/4-28 UNF; Lead armor: No; Unthreaded length: 0.0 in; Overall case length: 2.8 in; Total probe length: 1.0 m; Connector: Miniature male coaxial.
Confirm the current manufacturer document revision and the supplied item label before installation.
Match every suffix and modification number in 21500-00-28-10-02. Record the installed mounting geometry, connector, cable route, matched transducer components and receiving-channel configuration before removal.
After installation, verify the mechanical setting, signal polarity, bias or gap voltage where applicable, diagnostics and every affected monitoring or protection function.
