Overview
Manuals
Reverse-Mount Probe
System Fit
Gap Setup
Features:
- 21508-02-12-05-02 is identified by probe diameter 8 mm within the documented 7200 series 8 mm proximity systems configuration.
- The official specification gives mounting form as Reverse mount, which must be retained during selection.
- Commissioning must also preserve case thread (3/8-24) and the stated connection limits.
A legacy 7200-series 8 mm reverse-mount proximity probe for non-contact shaft vibration and displacement measurements. The code identifies a 3/8-24 threaded probe, 0.2 in unthreaded length, 1.2 in case, 0.5 m lead and miniature coaxial connector. Selection must preserve the complete label identity, connected-equipment compatibility and manufacturer installation limits.
Manufacturer reference: official 7200 series 8 mm proximity systems documentation.
Moore Automated supports exact-item verification and spare-part enquiries for 21508-02-12-05-02.
Bently Nevada 21508-02-12-05-02 official manufacturer document excerpt (PDF), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Confirm the complete 21508-02-12-05-02 identity and compare probe diameter, mounting form and case thread with the installed design before approving a replacement.
The probe must be used with the matching legacy 7200 extension cable and Proximitor calibration. A 3300 XL 8 mm component is not automatically interchangeable even when nominal sensitivity is similar.
Preserve reverse-mount orientation, case insertion depth and cable allocation, set the probe gap with the matched 7200 chain and verify the installed channel's linear response and alarm direction.
