Overview
Manuals
Enclosure Selection
Mounting & Access
Installation Checks
Features:
- The documented value for probe with connector is 3300 XL 8mm, with approval option; verify the connector interface, electrical length and matching probe-system components before commissioning.
- The documented value for probe cable length is 20 in (0.5 m); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented value for standoff adapter is Minimum length 1.5 in (38 mm); retain this specification when matching the exact proximity probe housing assemblies and installed probe-system hardware.
24701-28-05-15-026-03-02 is a Bently Nevada Proximity Probe Housing Assemblies for external proximity-probe mounting. It provides probe mounting, adjustment and environmental protection. Key specifications: Probe with Connector: 3300 XL 8mm, with approval option; Probe Cable Length: 20 in (0.5 m). Match the full order code and hardware before replacement.
Confirm the complete 24701-28-05-15-026-03-02 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The exact 24701-28-05-15-026-03-02 execution must be confirmed by its complete order code, condition, connected proximity-probe measurement system and included scope before purchase or replacement.
Bently Nevada 24701-28-05-15-026-03-02 Proximity Probe Housing Assemblies manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Check the complete 24701-28-05-15-026-03-02 housing code against the documented material, probe penetration, thread, fittings and access arrangement. Retained facts: Probe with Connector: 3300 XL 8mm, with approval option; Probe Cable Length: 20 in (0.5 m); Standoff Adapter: Minimum length 1.5 in (38 mm).
Confirm the installed probe, standoff, conduit fittings, sealing and machine-case interface together. A matching outside shape alone does not establish interchangeability.
Verify probe travel and gap access, tighten fittings to the approved practice, confirm sealing and route the probe lead without damage before returning the machine to service.
