Overview
Manuals
Modbus & Ports
Power & Environment
MNS iS Integration
Features:
- 1TGE120021R0010 is the complete listed product identity for the supplied hardware execution.
- The documented hardware is an ABB mns is mlink modbus communication gateway selected for its assigned equipment role.
- Installation requires a verified match to the documented ABB product family, the connected assemblies and the approved configuration.
1TGE120021R0010 is an ABB mns is mlink modbus communication gateway selected by its complete product identity and documented equipment role. Its suitability depends on the installed the documented ABB product family system, hardware execution, interfaces and application requirements matching the supplied unit. Visual similarity or a shortened code is not proof of interchangeability.
Before replacing 1TGE120021R0010, record the full nameplate, installed position, connector or terminal arrangement, paired equipment and relevant ABB service information. After installation, verify power, communication and control interfaces, complete the approved functional checks and confirm stable operation before returning the equipment to service.
The 1TGE120021R0010 ABB MNS iS MLink Modbus Communication Gateway is supplied subject to exact-item verification. Current revision, lifecycle status, availability and supplied scope are confirmed in the written quotation.
ABB 1TGE120021R0010 documentation and reference links.
Important Notice: Every linked document must identify the listed model or its documented family. Confirm the complete order code, hardware revision and installed-system requirements before replacement.
ABB Table 1 lists hardware ID 1TGE120021R0010 under the Modbus protocol for MLink. The manual describes Modbus RTU/TCP; the associated hardware interface options include RS-485 and Ethernet, RS-422 and Ethernet, or RS-232 and Ethernet. Verify the actual port population and protocol configuration on the supplied unit and project drawings rather than assuming every interface variant is installed.
ABB notes that MLink provides internal communication to MControl and external communication to the process control system. A dedicated switchgear-bus connector is selected to match a non-redundant or redundant system configuration. Keep the unit's connector arrangement aligned with the approved MNS iS architecture.
The V7.0 interface manual specifies 24 V DC supply with a 19–31 V DC range. Power consumption is 800 mA typical and 1000 mA maximum. Confirm supply polarity at the labeled +24 V DC and 0 V terminals and verify the upstream protection and cabinet design against the site drawing.
Published MLink data gives 140 × 160 × 165 mm H × W × D and 2.5 kg component mass. Storage is −20 to +70 °C, operation is 0 to +55 °C and enclosure protection is IP51. These are component specifications, not packed shipping dimensions or gross shipping weight.
ABB lists MLink protocols as PROFIBUS DP(-V0)/DP-V1, Modbus RTU/TCP and PROFINET IO; it states that the PROFINET interface is supported for ABB 800xA only. The exact requested ID 1TGE120021R0010 appears under the Modbus hardware selection, while the manual lists a separate ID for Profibus. Do not treat these protocol variants as interchangeable without confirming the complete item marking.
ABB system functions include MView web interface, OPC connectivity and time stamping across MLink types; availability may depend on the configured software modules. Confirm MNS iS release, MLink application/image, MNAVIGATE version, DCS interface, redundancy and connector set at order stage.
