Overview
Manuals
Ethernet & DDCS Interfaces
Installation & Compatibility
Technical Data
Features:
- NETA-01 is the complete listed product identity for the supplied hardware execution.
- The documented hardware is an ABB ethernet adapter module for abb drives selected for its assigned equipment role.
- Installation requires a verified match to ACS 800, the connected assemblies and the approved configuration.
NETA-01 is an ABB ethernet adapter module for abb drives selected by its complete product identity and documented equipment role. Its suitability depends on the installed ACS 800 system, hardware execution, interfaces and application requirements matching the supplied unit. Visual similarity or a shortened code is not proof of interchangeability.
Before replacing NETA-01, record the full nameplate, installed position, connector or terminal arrangement, paired equipment and relevant ABB service information. After installation, verify power, communication and control interfaces, complete the approved functional checks and confirm stable operation before returning the equipment to service.
The NETA-01 ABB Ethernet Adapter Module for ABB Drives is supplied subject to exact-item verification. Current revision, lifecycle status, availability and supplied scope are confirmed in the written quotation.
ABB NETA-01 documentation and reference links.
Important Notice: Every linked document must identify the listed model or its documented family. Confirm the complete order code, hardware revision and installed-system requirements before replacement.
ABB specifies an RJ-45 Ethernet interface for IEEE 802.3/802.3u devices using 10BASE-TX or 100BASE-TX, with 10/100 Mbps transfer and a maximum 100 m Ethernet segment. The manual recommends CAT 5 FTP or STP cabling for the Ethernet link. It documents HTTP, FTP, Telnet, Modbus TCP, SMTP and DDCS over Ethernet services; the relevant service and access permissions must be enabled and secured for the installed software version.
The drive-side DDCS connection is fibre optic, point-to-point and asynchronous half duplex at 4 Mbit/s. ABB specifies a two-station link with up to 10 m between stations and blue receiver / grey transmitter connectors. Multiple-drive configurations require the documented NDBU-85/95 branching unit or ring topology. Check channel numbering and all fibre connections against the drive manual before commissioning.
NETA-01 mounts on a standard rail and can be installed inside or outside a drive enclosure depending on the drive configuration. ABB requires the mounting rail to be correctly earthed. The module uses a 24 V DC auxiliary supply; verify polarity, source capacity, protection and the actual terminal arrangement from the manual and cabinet drawings. Switch off hazardous voltages and follow the drive-specific discharge and electrical safety instructions before work.
The module can use a drive tool channel for monitoring/debugging or a fieldbus control channel where the drive and application support it. Software version, drive parameterization, DDCS address, IP/DIP-switch settings, connected drive count, network policy and intended control authority must be checked and backed up before replacement. Do not infer that every listed drive supports every NETA feature or that field control is enabled by the adapter alone.
ABB gives NETA-01 enclosure dimensions of 93 × 35 × 76.5 mm (H × W × D), degree of protection IP20, and rail mounting. The specified current consumption is 80 mA at 24 V DC ±10%. Ethernet uses an internally terminated RJ-45 connector; the drive link uses separate fibre-optic transmitter and receiver connectors.
The manual lists operating ambient temperature 0 to +50 °C, installation temperature −20 to +70 °C and DDCS-link storage temperature −55 to +85 °C. Appendix B separately gives packaged storage/transport conditions of −40 to +70 °C; these categories are not interchangeable. ABB does not state a component mass in the reviewed manual, and component dimensions do not establish packed shipping dimensions or gross shipping weight.
